Bring tired, cloudy or faded pavers back
Paver Restoration and Resealing in Highlands, FL
Call (904) 479-2177 for a free Highlands paver restoration estimate with a written price for each step.
- Brings out deeper paver color
- Fresh joint sand helps lock pavers in place
- Gives weeds less room to grow
- Makes the surface easier to keep clean
- Free estimate, no obligation
Request a Free Estimate
Free, no obligation.
What counts as paver restoration at a Highlands home?
A local contractor handles paver restoration and resealing for Highlands homes, and the first reply arrives within 1 business day, often sooner. The inspection and the written price cost nothing. To get started, call (904) 479-2177.
Restoration is for pavers that have been sealed before and have gone wrong: a milky coat, peeling patches, joints that have emptied, edges that have drifted. The work strips what failed, washes the surface, refills the joints and seals again. Think of it as starting the paver job over from bare concrete. To have a contractor judge yours, ask for a free estimate.
Should my pavers be restored, or does a simple wash do?
A wash is enough when the coat is intact and only dirty. Restoration is the answer when the coat itself is the problem. A Tampa Bay stripping company says a failed sealer turns white or cloudy, usually from trapped moisture, a coat laid on too thick or a product that did not suit what was already there. Unilock lists the same trouble: moisture caught under the film, sprinkler water and hot pavers all leave a whitish look. To sort out which you have, call (904) 479-2177.
A Northeast Florida washing company puts it plainly, saying failed sealer gets stripped first, never coated over. That is the dividing line. If water soaks into the surface instead of beading, the coat is thin and a wash and a fresh coat may do. If the old film flakes or clouds, stripping comes first.
What is the paver restoration process, step by step?
Five steps run in the same order on almost every restoration. The contractor inspects, strips, washes, refills the joints and seals. Each has its own line in a good quote. To see how those lines would read for your driveway, ask for a free estimate.
1. Inspect and test
Low spots, loose pavers, old sealer and stains get noted. A small test spot shows how the pavers take stripper and the new product.
2. Strip the failed sealer
A stripper breaks the bond between the old coat and the paver. A surface cleaner with vacuum recovery lifts the residue, which a Tampa Bay company says is the only way to remove nearly all of it.
3. Wash the surface
Mildew, rust and dirt come off at low pressure. Western Interlock advises staying under about 1,500 PSI so the sand stays in.
4. Refill the joints
Old sand is cleared to at least an inch deep, then new angular silica sand is swept in, compacted and left about 1/8 inch below the surface.
5. Seal when dry
Sealer goes on dry pavers in one session. Cars and sprinklers stay off until the coat cures.
What does paver restoration cost in Highlands?
No page found for Northeast Florida prices the full restoration as one line, so the table is built from published pieces. One regional washing company posts $1.75 to $3.25 for each square foot of the full clean, sand and seal. A company's online calculator says stripping runs 20 to 30 percent higher than a standard seal, and the same calculator adds flat charges of $150 for moderate sealer failure and $300 for severe failure. For a price on your own pavers, ask for a free estimate.
| Paved area | Typical example | Standard clean, sand and seal | With stripping, 20 to 30 percent higher |
|---|---|---|---|
| 500 sq ft | Front walk and entry | $875 to $1,625 | $1,050 to $2,113 |
| 900 sq ft | Two car driveway and walk | $1,575 to $2,925 | $1,890 to $3,803 |
| 1,500 sq ft | Driveway and pool deck | $2,625 to $4,875 | $3,150 to $6,338 |
The middle column multiplies $1.75 and $3.25 by the area. The last column raises the low end by 20 percent and the high end by 30 percent. Flat add-ons for failure, solvent sealer or efflorescence are not in the table and are quoted after a look.
How do I tell if the old sealer on my pavers has failed?
Look for white or cloudy patches, flaking edges, a tacky or blotchy sheen and color that looks washed out between the joints. Water that soaks in fast instead of beading means the film is thin, a sign one Northeast Florida paver company points to when a new coat is due. Pavers near the pool that shift underfoot or joints that sit low also point to restoration, according to a Florida paver repair company. If you see two or more, call (904) 479-2177.
Photos help a contractor give a first opinion, but only a walk across the surface settles it. Bring up any sprinkler heads that spray the pavers when you ask for a free estimate, since trapped irrigation water is a known cause of white marks under a coat.
Can pavers that have sunk or shifted be fixed during restoration?
Often, and this is where restoration differs from a plain reseal. A Florida paver company describes lifting each uneven paver, adding new screening sand to the base, compacting it with water and setting the paver back with fresh joint sand. Unilock notes that sealer will not repair drainage or base trouble, so leveling has to come first. Sandy ground and hard summer storms, common in the area, move base sand over time. Tell the contractor about low spots when you call (904) 479-2177.
What do hard Highlands summers do to a sealed paver surface?
The area has a humid subtropical climate, about 52 inches of rain a year and July highs near 92 degrees. Rain falls hardest from May through September, and a Northeast Florida washing company says summer storms pull sand out of driveways and pool decks. Full sun, chlorine and storms are the reasons it gives for a coat lasting nearer two years than five. Soil in the area is mostly sand and clay, so loose joints invite weeds fast. To plan around that, ask for a free estimate.
A tidy cycle looks like this: restore once, wash every year, top off the joints after a rough season and reseal when water stops beading. A paver sealing calculator in the region recommends an annual cleaning and inspection for the same reason. Ask about a maintenance rhythm when you call (904) 479-2177.
Which sealer finish suits a restored Highlands driveway or patio?
Unilock says high gloss can be slippery when wet and that water based sealers give a lower gloss, matte look. Solvent based sealers give more shine and fit busy areas but need pavers and joints that are perfectly dry. One Northeast Florida company lists a wet look finish among four it offers, and a calculator lists a $75 charge for wet look and $250 for solvent sealer. Decide on shine and grip before the visit, then ask for a free estimate.
Restoration is the easy time to change finish, since the old coat is gone. If a homeowners association has rules on gloss, check them before choosing.
Ready to restore your Highlands pavers?
Share a few details and a contractor replies within 1 business day, often much sooner.
Free, no obligation
What do restored pavers look like around Highlands?
Which Highlands streets and nearby towns can book paver restoration?
Restoration estimates are open to Highlands homes and to each town in the list. Coverage spans Duval County and neighboring counties. If your street is not listed, call (904) 479-2177.
What should Highlands homeowners know about restoring pavers?
How much do people charge to seal pavers?
A washing company in the region posts $1.75 to $3.25 for each square foot of the full job. Another company's calculator says stripping runs 20 to 30 percent higher than a standard seal. Compare quotes line by line, since a low number often skips prep.
How do you rejuvenate old pavers?
By taking them back to clean, bare concrete and starting over. The contractor strips any failed sealer, washes the surface, replaces the joint sand and applies a fresh coat once everything is dry. Pavers that have sunk need leveling first, because sealer cannot lift them.
How do you refurbish old pavers that have faded?
Fading usually means the sealer wore off and UV light bleached the surface. Cleaning brings back much of the color, and a new coat deepens it again. A paver restoration company in Florida lists wet look or natural finishes, so pick the sheen before the visit.
Do you tamp down sand before laying pavers?
The base sand is compacted when pavers are first laid. In a restoration the joints are the focus: old sand comes out to at least an inch deep, new sand is swept in and a plate vibrator or hand tamper settles it. Trident, a sealer maker, describes that order.
Is it good to seal pavers in Florida?
For most pavers, yes. Unilock says sealer helps hold color against strong sun and makes washing easier, though it also calls sealing optional for its own pavers. Restoration is where the choice gets made, since the pavers are bare and clean.
Why is paver sealing so expensive?
Most of the cost is preparation. Stripping, a gentle wash, drying time and fresh joint sand take the hours, and the sealer is the smaller share. One Northeast Florida washing company says empty joints or failed sealer turn the work into a two day job.
Can old sealer just be coated over?
Rarely. A Tampa Bay stripping company says resealing over failing sealer turns white again, and worse than before. Unilock says to test whether old and new sealers are compatible. When the old coat is peeling or cloudy, it comes off first.
How long does a Highlands restoration last?
A Northeast Florida calculator says seals last 3 to 5 years and driveways sit nearer 3. Another says two to three years is typical there, shorter with full sun, chlorine and storms. An annual wash and check is worth planning for.
When is the right season for paver restoration in Highlands?
Fall tends to be easiest. The area gets about 52 inches of rain a year, mostly May through September, and a Northeast Florida washing company names October and November as the drier window for sealing. Unilock wants 24 to 48 hours of clear weather around the coat.
Does restoration fix sunken or wobbly pavers?
Yes, as a repair done before sealing. A Florida paver company describes lifting each uneven paver, adding screening sand, compacting it with water and resetting the paver with new joint sand. Tell the contractor about low spots near the pool or garage.
Want a written restoration price?
Call or use the short form, and expect a reply within 1 business day, often much sooner.
Free, no obligation